Mods/STC's/PMA's
Over the last 20 years, Airwork NZ has developed a range of modification packages, STC’s and PMA items. In addition, our unique combination of design and manufacturing skills and facilities means that we are able to tailor new design solutions to suit your needs.
MOD - Modification
A modification is a part designed and manufactured by Airwork NZ. The item can only be installed by Airwork NZ.
STC - Supplementary Type Certificate
A part designed and manufactured by Airwork NZ. Able to be installed in any aircraft in New Zealand and overseas where NZ CAA-approved STCs are recognised.
PMA - Parts Manufacture Authority
Authorisation by NZCAA to manufacture a duplicate OEM (Original Equipment Manufacturer) part.
Airwork NZ MODS/ STC’S / PMA’S
EC130 Snow Shoes
This modification installs a set of Snow Shoes to the rear end of the skids on an EC130 helicopter. These Snow Shoes provide extra stability for the skids when landing on soft or uneven terrain.
EC120 Frost Lights
This modification provides additional light source for night operations such as horticultural frost protection. No specialist tooling is required for fitting and removal.
AS350/355 Dual Front Seats
Optimise tourist passenger operation with Dual Front Seats. This STC enables quick and easy removal. Available in a wide range of leather or fabric finishes.
BK117 Particle Separator STC.AW.3022
The inlet particle separator is installed to the forward end of the air intake on top of the main cabin. The separator uses centrifugal flow tubes to separate particles such as sand and dust from air. Electric scavenge fans extract the dust-laden air and discharge it overboard via a ducting system. The inlet particle separator is intended to reduce the amount of particle contaminant in the air, and thus reduce the damage to engines, oil cooling fans and generators.
BK117 8 Place seating STC.AW.3014
This Airwork (NZ) Limited modification provides BK117 Eight Place Seating. All seats face forward and the seating is configured in three rows with the Forward and Aft bench seats both seating three people.
The Middle row consists of two single seats on either side of the cabin. No special equipment is required for installation or removal.
The fixed parts for the seats can be installed IAW this modification, but if the aircraft is already fitted with the original factory fixed parts, this is not required. This seating configuration uses any lap belt that conforms to FAA TSO C221.
AS350/355 Skid Protector Kit PMA.AW.0003
These Airwork (NZ) Limited manufactured parts are designed as alternative replacement items for protecting Eurocopter AS350/AS355 Landing Skids.
BK117 Fuel Pumps STC.AW.0010
This modification replaces the four existing electric fuel pumps with alternative cartridge type fuel pumps. The purpose is to allow removal of a fuel pump cartridge from its associated housing, without draining the respective fuel tank. The replacement fuel pump and related items are the same as those used on the Eurocopter BK117 series rotorcraft.
AS350 Pilot Seat Relocation Kit for Cargo Slingwork STC.AW.3027
This Kit relocates the pilot’s seat 89mm to the right to permit a superior view under the aircraft during external sling load operations. Seat change over has recently been simplified for this modification, and can be performed within a few minutes, allowing easy conversion from sling load work to passenger work.
AS350 450lb Hoist Kit STC.AW.3026
The hoist installation is designed to lower or haul aboard people or loads while the aircraft is hovering using a Breeze 450lb Electric Hoist.
EC120 Cargo Hook
This modification installs a Cargo Sling to the Eurocopter EC120 helicopter providing it with the means to fit a cargo hook for lifting and transporting underslung loads.
We invite you to contact John Simcox to discuss your requirements:
Design and Manufacturing Services Manager
Renton
Campbell
Phone +64 9 295 2134
Email renton.campbell@airwork.co.nz